Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SCN not working, but trunks show idle??
- Thread starter Z-man
- Start date
When your trunk is up (in SSA) that only means that the IVRIP packages are received in the system that shows up on the trunk
if both sides show up then it should work.
When in doubt reboot the satellite system and try again, if that fails as well then reboot the main system.
If that fails delete the trunks, reboot and recreate with a reboot
You can tell if it gets any information if it tries to occupy the trunk when you dial an extension from the other side, if you only get wave off then they don't exchange user information which they usually request after a reboot
Joe
FHandw, ACSS (SME)
Remembering intrigrant 2019
if both sides show up then it should work.
When in doubt reboot the satellite system and try again, if that fails as well then reboot the main system.
If that fails delete the trunks, reboot and recreate with a reboot
You can tell if it gets any information if it tries to occupy the trunk when you dial an extension from the other side, if you only get wave off then they don't exchange user information which they usually request after a reboot
Joe
FHandw, ACSS (SME)
Remembering intrigrant 2019
- Status
Similar threads
- Question