if you follow the stepe below your LX should work
Change node-names ip
CLAN 151.33.2.1 ( Customer supplied ip address )
Add / Change ip-interface
N c-lan 01bxx definity 255.255.0.0 151.33.3.1 1
Change ip-interfaces
Y
Change ip-services
Sat y definity 9001 any 0
Add data
Type Ethernet
Port 01axx17
Change node-name audix
Change Com Pro
Y audix s 1 5002 audix 0 1 1 1
ON Prologix
Change system maintenance
Page 2 set packet intf2 = y
Add Stations
Type = 2500
Page 2 = audix
Add Hunt Group
Message Centre = audix
AUDIX
Login using craft and crftpw or sa and sapasswd (crftpw)
Set The time- Basic system admin /date
Check system status under System config and status
Add the modem – Basic/Modem/Install (change speed to 9600 on port 2 and save)
Set up remote access- Basic/TCP/ppp (set up default addresses and record them)
Connect to Lan – Basic/TCP/Network (update with relevant info
Host name leave as default, add intuity ip address and subnet
Install British Language- Utilities/Software/Software Install.(click on cd and continu)
Go back to main and do a reboot- (Utilities/reboot)
Install Switch over lan software via the disk supplied using the same process as installing a language. Click on restart system when software is installed.
Select the switch selection- Basic/Switch and save
Stop and Start the messaging software via the Utilities menu.
Administer Switch administration- Switch/Switch (fill in relevant info)
Switch No 1 , Ip address of definity, port 5002
Stop and Start the messaging software via the Utilities menu
Administer channels and number settings- Voice /Call/Add Allowed
Enter the range and save
Activate the channels- Voice/Voice/PBX to.(start 0,1,2,3 if 4 port)
Go to the main again- Voice/Voice/Services to (type all and save)
Go to the main again- Voice/Number/Assign (make sure that it has any any audix from top to bottom and the others (to) blank and save
Back to Main-Voice/Voice/State (type all in equip no. and change immed to yes)
From the main-Diagnostics/Voice/Display (Verify they are all INSERV)
Change passwords-Basic/Password/Assign change
Restart system
Go into Global/Messaging (type your password to login)
Type change machine (change the Machine name and put the start ext and the end ext, you will then have to put a password on page 2 then Enter
Type Ch sys out- (change to active y)
Type ch sys fax and ch to denied depending on customer requirements
Type Ch Sys fe- (go to page 3 and set transfer type to enhanced_cover_0 and make system announcement british)
Type Ch Cos 0 and set outcalling to yes
You should now be ready to rock and roll.
