S8300C with Comm Manger 3.1.3 1

[joe8413]

Hi!

This is the first time I'm installing an S8300C with CM 3.1.3. Its asking for partitioning, but I leave values default. After the part were it says "Run Audix" I hit OK and it gives me a message that "Mount: block device/dev/cdrom is write protected, mounting read only" that message is on the bottom. After I continue I get this message: "Press OK to reboot now. This software requires reboot in order to continue."

Would like some feed back if anybody has encountered same issue.

Thanks!

 

[mrjedi]

s8300C will work from CM4 only. You need to replace this with s8300b server

 

[joe8413]

I appreciate that valuable information u just gave me. Will install CM 4.0

Thanks!

 

[mrjedi]

welcome