S8300/G700 for the first time

[bancci]

Hi there!
I 'm administering S8300/G700 for the first time. I have installed S8300 in G700, powered up, but I have problem regarding Login and Password. I can't start web browser or telnet to get to S8300. I used craft Log and dedicated Pass, but no success.
I know that Log and Pass are avoid over Forum, but if anybody knows what is a problem, please contact me on banei@algotech.co.yu

thanks a lot...

 

[BuckWeet]

default is craft and craft01

this is only valid before the license and authentication file is applied, so its no biggie to post this.. you can't use the system without those 2 things anyways..


BuckWeet

 

[petran]

Be very careful, if the S8300 is rebooted before you install the license and password file you will be locked out (no password will work). You will then have to contact Avaya to unlock the system...

Petran.

 

[BuckWeet]

Petran, where did you hear that?? I've never had that issue..

Let alone once you install the license and auth file you need to go into the system and do a "save trans" you might need to do a reset sys 4 before the save trans to get the features to show up..


BuckWeet