Route-pattern between CM5.1 and stand-alone CME?

[atod]

I would like to establish 4 digit dialing between the CM5.1 and CME but not exactly sure how to configure the RP. Both CM5.1 and CME router can ping each other.

 

[encarter]

have you tried an ICT (intercluster trunk) with the CME router?

 

[whykap]

Also an h323 gateway will work.

 

[atod]

We are using H323. I added the CME H323 gateway to the CM and created a RP 78XX, now I 4 digit dialing from CM phones to CME phones but not vice-versa. How do i setup the CME gateway to communicate w/ the phones reqistered to the CM? If possible, I want the CME to be stand-alone to avoid further upgrade/re-configuration of the CUE voicemail.

 

[pndscm]

Assuming CCM extensions are 56XX

dial-peer voice 22 voip
destination pattern 56..
session-target ipv4:<ip address of CCM>
forward digits 4

Should be close. Doing this from memory.