I was asked about this topic several times during the last days.
The way it works is:
Insert a serial board in the ipLDK-24 Nexer. MFP board.
Install a TFTP server on your laptop.
Use the .bin file provided for the s/w in your ipLDK-24 Nexer.
You laptop must have a serial interface.
A serial cable is also needed.
The commands are send though the serial cable and the ipLDK-24 Nexer boots and downloads new software.
It is possible to rescue ipLDK-24 Nexerversion 1.0 and 3.x with these procedures. Often the ipLDK-24 Nexer are defective after a s/w upgrade.
To obtain the written detailed procedure use the link below for contacts.
///doktor
____________________________________
The way it works is:
Insert a serial board in the ipLDK-24 Nexer. MFP board.
Install a TFTP server on your laptop.
Use the .bin file provided for the s/w in your ipLDK-24 Nexer.
You laptop must have a serial interface.
A serial cable is also needed.
The commands are send though the serial cable and the ipLDK-24 Nexer boots and downloads new software.
It is possible to rescue ipLDK-24 Nexerversion 1.0 and 3.x with these procedures. Often the ipLDK-24 Nexer are defective after a s/w upgrade.
To obtain the written detailed procedure use the link below for contacts.
///doktor
____________________________________