rickyoswald
Programmer
I am not sure what units it is measured in but in Access 2003 I can only stretch it out to '56', which is about two and a half pages in landscape. Is there a way to stretch it further?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Report width limit? 2
- Thread starter rickyoswald
- Start date
- Status
-
1
- #2
MarkSweetland
MIS
I vaguely remember Access reports or forms widths being limited to 22 inches...
Mark
"You guys pair up in groups of three, then line up in a circle."
- Bill Peterson, a Florida State football coach
-
1
- #3
...which is approx 56 cms
________________________________________________________________
If you want to get the best response to a question, please check out FAQ222-2244 first
'If we're supposed to work in Hex, why have we only got A fingers?'
________________________________________________________________
If you want to get the best response to a question, please check out FAQ222-2244 first
'If we're supposed to work in Hex, why have we only got A fingers?'
- Thread starter
- #4
- Status
