Removing VoIP Configuration 1

[telcomwork]

I'm trying to remove a VoIP connection that was using PRI carrier medium and signaling via a Paradyne CSU/DSU.

When I try to remove the sig group I get the following message, "Must remove administered NCA TSCs before removing signaling group"

Here is the sig group config. When I try to remove the NCA/TSC it won't accept 0 for Trunk Group for NCA TCS or for Max number of NCA TSC ..

Any thoughts to remove this darn sig group?

Group Number: 8 Group Type: isdn-pri
Associated Signaling? y Max number of NCA TSC: 8
Primary D-Channel: 02A1424 Max number of CA TSC: 0
Trunk Group for NCA TSC: 8
Trunk Group for Channel Selection: X-Mobility/Wireless Type: NONE
Supplementary Service Protocol: a

 

[telcomwork]

When I try to remove the trunk group I get "Must remove Trunk Group for NCA TSC entry from Signaling Group form first

 

[telcomwork]

Never mind.

 

[antonyn]

telcomwork
you need to disable the nca tsc in the sig group first the enter then go back in to the same page and remove them

 

[telcomwork]

Yeah figured that out after a minute or so... Thanks for trying to help me!