Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

RAD IPMUX, PRI Programming

Status
Not open for further replies.
runlun

runlun

IS-IT--Management
Dec 12, 2006
106
NO
Hi

I've got some problems programming the pri parameters to match the Rad IPMUX 1 setting. The IPMUX'es have been setup to use UNFRAMED line type. The clock on the main site is set to loopback and on the remote side it's set to adaptive. Both systems are writing alot of slip error messages, and the D-Channel can not establish

I've tried different combinations on both the RAD Ipmux and on the switch

Does anyone got a clue how to fix this issue?
Thanks in advance

Kind Regards
runlun
 
Status
Not open for further replies.

Similar threads

G
  • Locked
  • Question
Remove PRI card
Replies
6
Views
360
telekon7
telekon7
LidLock Technologies
  • Locked
  • Question
Meridian 1 Basic programming
2
Replies
26
Views
1K
bignose21
bignose21
Mokpokpo Agbovon
  • Locked
  • Question
Analog Phone Programming
Replies
4
Views
552
Firebird Scrambler
Firebird Scrambler
lexer
  • Locked
  • Question
Meridian 11c and asterisk interconnection using PRI
Replies
7
Views
699
RS528
RS528
BRUE23
  • Locked
  • Question
NTDW20 programming
Replies
4
Views
351
BRUE23
BRUE23

Part and Inventory Search

Sponsor

Back
Top