Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NTDW20 programming

Status
Not open for further replies.

BRUE23

Vendor
Joined
Apr 4, 2023
Messages
3
Location
US
Have worked/repaired these for some time but have a unit that says on boot "to change configuration enter mgcsetup".
After entering IP info it asks for "ADA MGMT IP address".
I have never seen this before. If I bypass it returns to "to change configuration enter mgcsetup".
Anyone seen this or can be of any assistance?
Thank you
 
I thought ITS like an MGC (Apart from having 2 ports one for each shelf) you just do IP Address/Mask/Gateway and CS Address, then no to the Advanced Parameters
 
maybe it is in a sec domain and after the UCM/SMGR whichever you are using
 
Thanks bignose, the cards were connected to Avaya Aura so we had to default/replace hardware to get them back to "normal".
Thanks for your help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top