R6 Linux Base Patching

[m31690]

Getting ready to upgrade a R5.5 CS1000MG to R6
Have three new Dell R300 Servers to replace old ISP1100's
Preloaded Linux Base on them in Shop on test LAN
Setup one as UCM primary and other two as member Sig Serv
Down loaded the latest PEPs & SU from ESPL and followed instructions to install Linuxbase pep first. When I try to upload the file to UCM in patch manager I get a Invalid file error. Has anyone else had this problem?

 

[monkey101]

make sure you have the uCM sever as a trusted site...i was getting the same thing until i changed that and then everytinhg worked ok

 

[m31690]

Thanks monkey101, Will give that a try after the long holiday weekend

 

[m31690]

Adding the IP addr to the trusted site list fixed the issue

Thanks monkey101