-
1
- #1
Just thought I would share my experience last night on an Option 81 running 6.0 with Pentium IV Processors. I was installing a new Deplist so I split the Cores, this was a Hospital so not taking any chances.
1. Split the Cores so side 0 was active and side 1 inactive
2. Loaded new Deplist on side 1
3. Issued Cutovr command to go to side 1
4. Installed new Deplits on side 0
5. Tried to join, no go, said it was in a syncing state
Called our support group, he found a solution where you should only load the deplist on one side, the active side, then join the inactive side and let the patches flow from active to inactive. So I removed the deplist from side 0 and then it would let me join and sync. I have done this in the past without issue. Not sure why this beast was giving me so much trouble, but there you have it. Also patched Crash Pilot from 5.00.41 and took it up to 5.1 without issue.
1. Split the Cores so side 0 was active and side 1 inactive
2. Loaded new Deplist on side 1
3. Issued Cutovr command to go to side 1
4. Installed new Deplits on side 0
5. Tried to join, no go, said it was in a syncing state
Called our support group, he found a solution where you should only load the deplist on one side, the active side, then join the inactive side and let the patches flow from active to inactive. So I removed the deplist from side 0 and then it would let me join and sync. I have done this in the past without issue. Not sure why this beast was giving me so much trouble, but there you have it. Also patched Crash Pilot from 5.00.41 and took it up to 5.1 without issue.
