QSIG D/240-JCT-T1 1

[teekow]

Does anyone have a Nortel meridian working via QSIG to a dialogic D/240-JCT-T1 who could post a working config? I need dchannel, route, and trunk as well as the choice that was made in the dialogic config for firmware (QTU, QNU, etc..)

Right now, I am set to trunk type DID, but I am thinking it should be TIE since I am unable to tandem out to the PSTN.

I don't want to have to perform the "try this" method of install. Much prefer a known working config.

Thanks
Rob

 

[johnpoole]

try this one, it has worked for a lot of app here in the forum

http://www.tek-tips.com/viewthread.cfm?qid=1017219

john poole
bellsouth business
columbia,sc

 

[teekow]

that one did work.........thanks very much

next question which I think is more of a sanity check for me is can I use a trunk side QSIG T1 and still have the 3rd party dialogic card use a hookflash to transfer to another DN on the Nortel PBX and NOT trombone onto another b-channel?

My first thought is no, that is what lineside T1s are for, but I must admit I haven't specifically read this anywhere.

Any ideas are appreciated.
Rob