QSIG connection- Erricson PBX with Nortel PBX rls 4.5

[kondalisa]

I i have connected a Ericcson PBX with Nortel 11c rls 4.5 using E1 connectivity. It is working Ok accept i dont get name or number when a erricson extension calls nortel pbx extension. i get only the route and member number. I tried different RCAP entries but no success. The Nortel extension number and name is displaying ok on erricson extension. EWhen i check Dchannel msg it shows no CLID.
Does anybody have any experience connection erricson pbx with nortel and name/ext number displaying at both side??? can somebosy put a sample or RDB/TIE trunk from there practical experience.??
Regards

 

[telebub]

The RCAP settings on a QSIG PRI to an Asterisk is:
MWI COLP NDI QMWI

The RCAP settings on a QSIG PRI to a Cisco are:
COLP NDI CCBI CCNI PRI DV3I CTI QMWI

Also, the IFC of the D-channel on each is ISGF

I'm not sure these will help with an Ericson but these settings work great with these systems.

War Eagle!
Lions Baseball '09!

 

[kondalisa]

Hi Pal , tried these settings but no success, DCH messaging still shows no CLID from ericsson, can somebody post both PBX settings for name display??? I also tried this on ericsson forum but still no answer.
Regards

 

[SL1M1]

Is the Ericson PABX allowing the CLI/Name Display as it would seem your all set up from the Dchannel side also check your Ericson Qsig Route on the ISDN settings are allowing it

Cheers!!

 

[telebub]

Do you have your SIDE set up properly on each switch? Where you are NET and the Ericson is USER or vice versa?

War Eagle!
Lions Baseball '09!

 

[kondalisa]

Ericsson guys says this configuration of ericsson is working with avaya/alcatel and Siemens and they are sending name and CLI when they check there end through trace.
Hi telepub, i think SIDE=NET or User belongs to same PBX connectivity i mean when both tied PBX are Nortel.
Any more advice??

 

[SL1M1]

Confirm that you have the correct Dchannel RCAP settings as previous posts hinted and the changes you made where ForceDownLoaded (FDL) onto your MSDL, have you also checked your Route Data Block RDB you have for the MD110/Ericson I guess ?

Cheers!!

 

[alberto111]

Have u made this issue to up?...Can u send ur correction u had changed in thid config...bcos iam facing the same issue.