Programming ANI 1

[sadieselbow]

Hi there, I am new to definity and taking care of PBX. I need to know where to go or how to create ANI using the PBX. I may be mistating my request, but hopefully someone gets the gist.

Thanks

 

[kashbrook]

Enter CHA FEAT (CHANGE FEATURE ACCESS CODE) and near the bottom of page 3 you should see "Self Station Display Activation". Enter a unique three-digit code such as 616 then press Enter or F3. Test by going to phone that has a display and enter the code you created. Hope this helps.

 

[4merAvaya]

If you are trying to administer the number that is sent when you make an outbound call, assuming you are using ISDN trunks, you would either use 'change public-unknown' or 'change isdn public-unknown'. The command varies with software load.

Kevin

 

[kwajtech]

Atr you trying to Verify the extension your calling from if so then you can look at this FAQ

http://www.tek-tips.com/faqs.cfm?fid=4624

 

[sadieselbow]

Thanks for the post. I did misstate my question, but you were smart enough to understand what I was looking for.
I was looking how to program the service for verifying the number I am on.

Another question, is how to make the system perform a call back verification.