problems with W2K as router

[zwam]

Hi,

I can't get my clients on internet, however everything looks well configured (which probably won't, otherwise i wouldn't open a thread).

So, i have my server connected to my lan-modem with DHCP-assigned. That's ok, the server gets its ip-address.
Another NIC is serving IP's to the clients, which works fine too.

Routing and remote access are configured using the NAT-protocol.
The DNS is working fine: he passes the queries to other dns-servers and to itself and nslookup from a client gives correct inf. about that client.
The DNS is no longer a root-server, i removed the .zone and added forwarders (dns's from my ISP), which i can ping and which are listed at ipconfig/all.

I can access the internet from the server.

What else should i check (or tell) ?

 

[cbbxxxd]

maybe this will work...
did you configure the clients comupters RRAS service...
it's set at auto, set it to manual and start it up
reset the ip addresses and it should work...
happy holidays.....

 

[zwam]

Thanks for your reply; but that wasn't the problem.
I've completely reïnstalled the server with the same result.
After trying everything, i found the problem:
my primary adapter which was connected to the internet, hadn't file and printer sharing on.
So all had to do was to change which was the primary connection and it works !!
Thanks anyway