Problem with starting routing and remote Access service

[ghostwarrior106]

Hi there,
The problem I am getting is as follows:
I am running Windows Server 2003 Standard Issue, I had set up a VPN that was working correctly, all fine. Then I installed Exchange Version: 6.5.7638.1, this seems to be working ok, I tried to log on a remote client and it failed. I checked the server logs and found the following errors:

The Routing and Remote Access service terminated with service-specific error 2 (0x2).

For more information, see Help and Support Center at

http://go.microsoft.com/fwlink/events.asp.

Unable to load C:\WINDOWS\System32\iprtrmgr.dll.

For more information, see Help and Support Center at

http://go.microsoft.com/fwlink/events.asp.

Also when I check in services I find that routing and remote access is not running, when I attempt to start it I get the following:

Windows could not start the Routing and Remote Access on Local Computer. For more information, review the System Event Log. If this is a non-microsoft service, contact the service vendor, and refer to service-specific error code 2.



I have tried to resarch this myself and found some articles but of no help, so I thought that one of you guys would have come accross this before most likley and tell me the problem....

Thanks in Advance

Mark N

 

[schtek]

two areas i would think about after the exchange install your Routing and Remote Access was altered by the exchange,check settings, why not reinstall it again!!

"Research is what I'm doing when I don't know what I'm doing."