problem with new setup of pix 515

[notbroken]

I am trying to setup a pix 515 to segment part of our network.

rest of corp network - router A - pix - hub - workstation

There are public addresses on the inside network and they are to go outside without translation. All x.x.24.0 will be on the inside.

Currently, I have 1 computer setup on the inside and I am unable to ping the outside interface of the pix.

Below is my config:

PIX Version 6.3(3)
interface ethernet0 auto
interface ethernet1 auto
interface ethernet2 auto shutdown
nameif ethernet0 outside security0
nameif ethernet1 inside security100
nameif ethernet2 intf2 security4
enable password 8Ry2YjIyt7RRXU24 encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
hostname fwbent
fixup protocol dns maximum-length 512
fixup protocol ftp 21
fixup protocol h323 h225 1720
fixup protocol h323 ras 1718-1719
fixup protocol http 80
fixup protocol rsh 514
fixup protocol rtsp 554
fixup protocol sip 5060
fixup protocol sip udp 5060
fixup protocol skinny 2000
fixup protocol smtp 25
fixup protocol tftp 69
names
access-list 100 permit icmp any any echo-reply
access-list 100 permit icmp any any time-exceeded
access-list 100 permit icmp any any unreachable
access-list 103 permit ip x.x.24.0 255.255.255.0 x.x.24.0 255.255.255.0
pager lines 24
logging on
logging timestamp
logging buffered errors
logging trap debugging
logging host inside x.x.24.15
logging host inside x.x.24.1
mtu outside 1500
mtu inside 1500
mtu intf2 1500
ip address outside dhcp
ip address inside x.x.24.1 255.255.255.0
no ip address intf2
ip audit info action alarm
ip audit attack action alarm
pdm logging informational 100
pdm history enable
nat (inside) 0 access-list 103
nat (inside) 0 x.x.24.0 255.255.255.0 0 0
nat (inside) 0 0.0.0.0 0.0.0.0 0 0
access-group 100 in interface outside
route outside 0.0.0.0 0.0.0.0 x.x.12.254 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225 1:00:00
timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00
timeout uauth 0:05:00 absolute
aaa-server TACACS+ protocol tacacs+
aaa-server RADIUS protocol radius
aaa-server LOCAL protocol local
http x.x.24.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server community public
no snmp-server enable traps
floodguard enable
telnet timeout 5
ssh timeout 5
console timeout 0
terminal width 80

Thanks,
Andy

 

[dopehead]

Firstly, an acl is only for the traffic through the pix, not to the pix itself. You need an icmp command like this to ping the outside.

icmp permit any echo outside

Jan


Network Systems Engineer
CCNA/CQS/CCSP/Infosec