Hi
I am trying to setup a Cisco 2600 Router that has an NM-16AM card installed. I want to be able to setup users on the system, so that they can either pick up a default address from the pool, or specify the address that they require, by adding it into the DUN setup on their Laptop.
So far I've only been able to get the router to accept addresses that are defined in the default pool.
This doesn't make much sense to me, as there is a chance that someone could dial in and request an address that has already been assigned.
Is there any way to setup the dial in so that the default addresses are in a different pool, to the ones that are preset on the laptops?
I am trying to setup a Cisco 2600 Router that has an NM-16AM card installed. I want to be able to setup users on the system, so that they can either pick up a default address from the pool, or specify the address that they require, by adding it into the DUN setup on their Laptop.
So far I've only been able to get the router to accept addresses that are defined in the default pool.
This doesn't make much sense to me, as there is a chance that someone could dial in and request an address that has already been assigned.
Is there any way to setup the dial in so that the default addresses are in a different pool, to the ones that are preset on the laptops?
