Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Printing problem in Approach 9.8

Status
Not open for further replies.

fff0hex

Technical User
Oct 15, 2009
1
0
0
AT
Hello,

I have a database (only 60 data sets) and when trying to print all of them, it only prints until it has reached data set 40, then starts from the first data set.

When I try to print data set #40 or above, it prints data set #1, from #1 to #39, it prints the correct one.
Suggestions?

kind regards,
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top