I am setting up DID numbers on the incomming "lines" and under the target line I have an issue setting up the received digits. I have it setup for (3) and the received digit I want to enter is 824. I can not type the 2 for some reason. When I press 2 on the hand set it types nothing. if I type on the second digit any other number then I can type 2... I also tried another hand set.. So the system rejects these lines when try to call in on them... The rest of the DID's seem to work fine. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
pri did received digits problem
- Thread starter tilefono
- Start date
82 might be in use as a pool code. If so you'll have to change it to something else in order to use 824.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Thread starter
- #3
Look under System Programming - Access Codes - Line Pool Codes
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Thread starter
- #5
Under line pool codes A-O are all set to none.
this is a PRI with 36 DIDs I only have trouble with the two line that are ending 823 and 824.
where does the system defines the rolover sequesnce?
is it part of the 157-284 line appearances?
I can use other lines insead of them..
By the way I appriciate your help. what is your company name?
this is a PRI with 36 DIDs I only have trouble with the two line that are ending 823 and 824.
where does the system defines the rolover sequesnce?
is it part of the 157-284 line appearances?
I can use other lines insead of them..
By the way I appriciate your help. what is your company name?
allworxguy
Vendor
- Status
Similar threads
- Locked
- Question
