Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Prairiefyre Exchange
- Thread starter TrunkMan
- Start date
What version of Prairiefyre?
I'm pretty sure the answer is yes.
We had to use remote exchange on 5.6 because the exchange version was 2007 ( 64bit only) and the PF server didnt support 64bit OS.
I believe that version 6.0 PF will support 64bit OS
I'm pretty sure the answer is yes.
We had to use remote exchange on 5.6 because the exchange version was 2007 ( 64bit only) and the PF server didnt support 64bit OS.
I believe that version 6.0 PF will support 64bit OS
- Thread starter
- #3
thanks for your response. Im currently doing a remote exchange installation, but cannot seem to get the exchange link up. What are usually the common causes for the link not coming into service ? Did you run into this on your install ?
Using 5.8CCM,MS Exchange 2003, MS server 2003 32bit.
Using 5.8CCM,MS Exchange 2003, MS server 2003 32bit.
- Thread starter
- #6
Yeah, Ive run the remote server config wizard on exchange and the MCC config wizard on the enterprise server, and have domain admin and full exchange admin rights. Do you also have to setup the exchange send connector for 2003 as well or is that just for 2007 ?
- Status
Similar threads
- Locked
- Question