port setting for c-lan board

[ohyes]

HI GUYS
Where can you lock down the port settings on a version 9.5
For example i want to lock down the c-lan to 100 full duplex. I was told to do ch ethernet. But this command does not seem to exist.

 

[NX01]

The command it "ch ether" Either you don't have the right login to make the change or the clan is not "on" in
"ch ip-inter" Is the clan the only ip device you have?

In the future everything will work...

 

[ohyes]

The c-lan board is currently working. I was told to check to make sure the port speeds where the same as what the far end switch is set to. I am logging in as craft.

 

[NX01]

You may need the dadmin login...

In the future everything will work...

 

[ohyes]

I have just logged in as dadmin and got the same result. I also not do display ether.

 

[NX01]

I haven't the slightest why you can't do it. They may have given you a dummy dadmin and restricted the ip portion of the login.

Do a "list logins" and see if dadmin is at craft level. It should read
Login Service Status
Level
dadmin dadmin active

In the future everything will work...

 

[PBXTech]

the command change ethernet is not available in r9.5
it is in r10 and above.
in 9.5, you'll only have 10/half.

 

[PBXTech]

also to get 100/Full, you'll need 4 things...
r10,
at least a TN799C,
and the tight twisted IO cable and adapter as listed in my faq.

http://www.tek-tips.com/faqs.cfm?fid=5370

 

[NX01]

GAH!

In the future everything will work...

 

[TykeUK]

Do change ip-interface xxxxx, where xxxxx is the card address of the clan.

Within this you can set the ethernet options.

 

[BuckWeet]

PBXTech, you need a TN799DP to be able to do 100/Full

TN799C only supported up to 10/half


BuckWeet

 

[PBXTech]

Yep, TN799DP you'll need, not the TN799C.

Well 3 outta 4 ain't bad.

FYI:

http://www1.avaya.com/enterprise/applicationnotes/av-iptel-imp-gd-acm-0503.pdf

 

[ohyes]

When i try the ch ip interfaces command i get hte following:
Eth Pt Type Slot Code Sfx Node Name
y C-LAN 01C02 TN799 C switch

Subnet Mask Gateway Address Rgn
255.255.255.0 xxx.xx .0 .1 1

 

[PBXTech]

ohyes, TykeUK's command works in CM2.0 and later where you use the cha ip-i command and the board location. Before CM2.0, i.e. CM1.3 down to Definity 9.5, you see what you pasted. You don't use the board loaction on the end of 'cha ip-i'.

 

[lopes1211]

It looks like a "C" suffux anyway. 10/half it is!

-CL

 

[ohyes]

Thankyou guys for your help.