Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Point-to-point configuration

Status
Not open for further replies.

tech84

Technical User
May 18, 2000
126
US
This is driving me crazy. I was trying to describe to a friend of mine how we had our "wan" set up in the Marine Corps. I was in the air wing and worked in the data communications dept. All I remember (and I wasn't the router expert, mind you) is that we had a 4000 series router in the data center that was connected to 4 or 5 remote squadron hangars, all of which were less than a half mile from the data center. It seems like it was some kind of serial point-to-point connection, but there was no telco involved. On the hangar ends, there were 4000 series routers plugged into something that looked like a serial modem or CSU/DSU, and I don't remember what was on the data center end.

My question is, can anyone describe what kind of point-to-point link that sounds like? Everything I can find on serial point-to-point connections involves the telco, or some kind of service provider in between. If I remember right, this was just a shielded cable, with maybe 4 or 5 conductors. Does this make any sense?

Thanks a bunch for your help!

Mike
[morning]
 
It sounds like they were using plain old serial connections with long haul modems. I think it would have to be pretty low speed but it would work.
 
Sounds like it could have been connected with via fiber and a fiber to ethernet converter that would connect to the router at each end. That would have no problem with that distance and no telco would be needed.
 
The normal thing used in the military would probably have been a flexilink fibre optic modem, it turns serial (x.21) into fire upto 8KM's then another one at the other end, working in a master slave. I know that we use them and the US AF use them.

Visit for free Cisco rack access.
 
Yeah, I think jneiberger must be correct. I neglected to give the time frame here... this was in the 1994 - 1997 era, so we didn't have anything too fancy. We did have a fiber backbone that went to all of the support squadron buildings and hangars, but the flying squadrons we supported had this serial setup. I said the hangars were within half a mile of the data center, but they were a lot closer than that. The furthest was probably about a quarter mile distant. It was definitely slow. It was only designed for 3270 terminal emulation and Banyan Vines e-mail service, so no web browsing.

Thanks again for your help!

Mike
[morning]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top