PIX 515e Routing Question.

[NicBurns]

I need to create a route on my pix box that will route data from the user’s pc when they are connected to the VPN, to another Cisco router inside the pix box. Now the address of the pix is 10.x.x.x and the router is 10.x.x.x but the address the router is NAT to is 32.x.x.x I can reach the 32 address by doing a route add on the pc locally but over the VPN they get a 192.x.x.x address and I can't do a route add from to the 10.x.x.x to get to the 32.x.x.x from the VPN. Hopefully this makes sense.

It's always a PEBKAC problem.

 

[bell1996]

Is the PIX configured for "split-tunnelling" for the VPN Client? Or is the PIX assigning all traffic to default on the client?

If you're using split tunnelling make sure to specify the networks you want to access in you ACL's.

Can you post you config?