Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PHTM 500 CFWD to an International number - HELP :(

Status
Not open for further replies.

underwoj

Technical User
Sep 13, 2006
199
US
Why won't this work on my CS 1000? I set my NCOS to 7 (which allows international) - then set my TGAR to 12 (which is good for this as my 1140 phone is set with NCOS 7 and TGAR 12 and it dials this international number just fine).....but why won't the 500 work? When I call the 500 built - it thinks about it for a minute then I get a 'fast busy'

Any insight would be greatly appreciated!!
 
Maybe post a print out of the phantom. Do you have CFXA in CLS of the phantom?
 
yep - I have CFXA...here ya go (TN attached)


DES ABSG
TN 128 0 10 05 PHANTOM
TYPE 500
CDEN 4D
CUST 0
ERL 00000
WRLS NO
DN 8040 1 MARP
CPND
NAME Bineet D Overseasa
XPLN 27
DISPLAY_FMT FIRST,LAST
AST NO
IAPG 0
HUNT
TGAR 12
LDN NO
NCOS 7
SGRP 0
RNPG 0
XLST
SCI 0
CLS UNR DTN FBD XFD WTA THFD FND HTD ONS
LPR XRD CWD SWD MWD RMMD SMWD LPD XHD SLKD CCSD LND TVD
CFTD SFD MRD C6D CNID CLBD AUTU
ICDD CDMD LLCN EHTD MCTD
GPUD DPUD CFXA ARHD OVDD AGTD CLTD LDTD ASCD
MBXD CPFA CPTA DDGA NAMA MIND
MCRD
EXR0 SHL ABDD CFHD DNDY DNO3
CWND USMD USRD BNRD OCBD RTDD RBDD RBHD FAXD CNUD CNAD PGND FTTC
CDMR MCDD T87D PKCH
PLEV 02
AACS NO
MLWU_LANG 0
FTR DCFW 20 90115213317451922
DATE 6 OCT 2015
 
damn - that worked so the calls now go out but sometimes they don't.....I tried 10 times and 8 calls were successful - the other 2 got fast busy. is that weird?
 
My guess is busy trunks. You would have to look at the RLI handling International calls and see if all the trunks are getting busy.
 
Yep check the trunks, you could get the Route from the RLI as KCFLHRC says and then in LD 80 "trac 0 acod" to see the status of all the channels. If you dont think it is a busy channel thing stick the DCH MON on in LD 96, and see if you can set an out bound setup message for every call may be a Carrier issue.
 
Check your TGAR 12 corresponding of your phaton DN and the route and trunks TAR also your FCR table .


Best regards;
SuperSistemas
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top