graham1950
Technical User
on small jobs ,m/c ok .but on large runs 50 plus a thumping noise comes from fuser area when duplexing and causes occasional jams in fuser . fuser looks ok to me .. any suggestions , please .. thanks graham
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
phaser 7700 thumping when warm
- Thread starter graham1950
- Start date
- Status
Sounds like the fuser has developed a flat spot, thus the thumping noise as it prints and the jamming. This happens if the fuser rollers sit in one spot against each other for long periods. Replacing it will probably resolve your problem.
- Status
Similar threads
- Locked
- Question
- Locked
- Question