Phantom Line

[johndeleon]

I would like to create a phantom line on our option 61c. How do I go about doing? Thanks.

John De Leon

 

[bigindian65]

Go to ld 97

create phantom loop 156.

CHG
supl
n156

enter on thru the rest.

go to ld 11
build 156-0-0-0 phantom TN

 

[johndeleon]

Once I go in to ld 97, what's the command to create the phantom loop? Can I check if we have any now?

John De Leon

 

[bigindian65]

prt
supl

if you have an N by the loop it is phantom

 

[TAnselm]

You can also check in ld 20 by asking for unused ports.

LD 20
REQ: LUU
TYPE 500

and you will get listing like the following
TYPE 500 TN 116 0 15 14 4D
TYPE 500 TN 116 0 15 15 4D
TYPE 500 TN 159 0 01 02 PHANTOM 4D
TYPE 500 TN 159 0 01 03 PHANTOM 4D
TYPE 500 TN 159 0 01 04 PHANTOM 4D
TYPE 500 TN 159 0 01 05 PHANTOM 4D
TYPE 500 TN 159 0 01 10 PHANTOM 4D
TYPE 500 TN 159 0 01 11 PHANTOM 4D
TYPE 500 TN 159 0 01 12 PHANTOM 4D
TYPE 500 TN 159 0 01 13 PHANTOM 4D
TYPE 500 TN 159 0 01 14 PHANTOM 4D
TYPE 500 TN 159 0 01 15 PHANTOM 4D
TYPE 500 TN 159 0 04 01 PHANTOM 4D
TYPE 500 TN 159 0 04 03 PHANTOM 4D
TYPE 500 TN 159 0 04 04 PHANTOM 4D
TYPE 500 TN 159 0 04 05 PHANTOM 4D
TYPE 500 TN 159 0 04 06 PHANTOM 4D
TYPE 500 TN 159 0 04 07 PHANTOM 4D
TYPE 500 TN 159 0 04 08 PHANTOM 4D
TYPE 500 TN 159 0 04 09 PHANTOM 4D
TYPE 500 TN 159 0 04 15 PHANTOM 4D

Phantom ports are pretty apparent here...

 

[johndeleon]

I understand the last part, but when I do to LD 97 what is the command to create a new phantom TN? I'm at the REQ prompt. I can see that I have two phantom TN's right now, but I want to create 3rd. Thanks.

John De Leon

 

[bigindian65]

97 is phantom LOOPs, if you are adding a TN, go to 11 or 20 and create a new TN off one of those Loops, if you have N96

you can have

96-0-0-0 - 96 0 0 1, 96 0 0 2, etc.

 

[acewarlock]

LD 20
REQ: LUU
TYPE 500

and post the results here so we can see what your talking about.