Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PGN on release 6.0 G3r Question

Status
Not open for further replies.

bwilch

Technical User
May 5, 2003
627
US
I'm looking to setup a time of day routing for a specific number and I'm familiar with the ARS settings, the COR settings, the time-of-day settings and the Route pattern settings. However, for some reason for the life of me, I can't find the partition route pattern settings page. When I do a display help in the switch, it isn't showing.

The switch has "time of day routing" enabled in sys cust and does not have "tenant partitioning" on.

Can someone help me fill the void? Thanks!
 
Did you try "change partition-route-table 1"? 1 is the first entry and all others will show as well.

cb
 
Yeah, the "ch part" shows up as invalid and again when I did the help, it didn't show the partition-route-table as an option.
 
Found my own answer, didn't realize there were multiple ARS ANA tables for each partition unlike in the new switches. Thanks for the attempt in help though cb369!
 
To set up ARS partitioning in R6 and earlier you should use command 'ch ars ana 0 part <n>', there <n> is the number of partition you want to change.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top