Personal CO outbound setup 1

[PhoneDataDude]

I am playing with setting up a Personal CO trunk for one of our analog lines. I can get calls routed to a station just fine. I programmed a button for the Per-COLine, but when that button is selected, I get a denial event 1010: TEG denied origination.

What do I need to set to get that button working?

 

[PhoneDataDude]

Just for grins I reset the system and was able to make one call via the personal CO button. Now it's back to the fast busy. I have tried to busy the board with no luck. Any thoughts?

 

[PhoneDataDude]

Just needed to change it to loop start. Now all is well.

 

[Getter]

I need a little help in this area, ... how did you get calls routed to the station ... What config on the switch did you have to do? ... I have a trunk with two outside lines. I want to use one for incoming calls and have them routed to the station. The other outside line i want to setup so that when an agent makes an outbound call from the agent client application which is tied to a station for that agents login it will dial out on that line ( agent has station 4003 can call on the switch to other stations) but I want to make a real call on the outside line to an external phone (my home phone) etc for testing. Any help is appreciated, .. thanks much!