Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Perforation

Status
Not open for further replies.

DavidANGERS

Programmer
Sep 21, 2005
2
FR
Hi,


I'm trying to send pcl codes to perfore pages. I've found the <ESC>&l0L and <ESC>&l1L codes but their rule seems only to define appropriate margins.

Does anyone knows how to "say" to the printer to act the processus of perforation ?

Thank You

David, Angers (France)
 
The commands you mention arre to disable and enable 'skip perforation' mode.

All this does, as you have discovered, is to allow, or prevent, access to the region at bottom of one page/top of the next, which might normally be considered as a margin area.

The PCL language does not include any command to cause the printer to actually create perforations in the paper.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top