Per port bandwidth Cisco 4506

[PhoneDataDude]

Is it possible to limit bandwidth on a port by port basis on a 4506. We will have all gig ports, but we don't want to give everyone full bandwidth. We have enough older 10mb machines that doing per port speed would be a hassle.

 

[KiscoKid]

You can traffic shape at port level. I've assumed you're probably using an IOS switch but anyway the following link shows how to set it up:

http://www.cisco.com/en/US/products...tion_guide_chapter09186a008019d0e5.html#38559

HTH

 

[PhoneDataDude]

So using TX-Queue 1 and shape percent 10 would be a per port percentage, or a percentage of the entire transmit queue? Can the uplink ports be left a native speed? The goal would be to allow a few high bandwidth clients to get full gig speed, and limit the rest.

Thanks!