Password lockout on winCE 5

[Glivanis]

OK, here what my problem is:
Recently I was playing around with an unbranded winCE 5 GPS device. I bypassed the original interface and boot into winCE environment. I set it to ask for a password, on each boot. So far so well, but on the next boot, there was no virtual keyboard on screen, in order to enter the password. So, the device has locked me out.
I unplug the battery for a couple of hours, several key combinations trying to hard reset the device but no luck...
Note that the USB/ActiveSync function is disabled.
So, should I forget about it, or is there any way around ?

 

[jh787]

have you managed to work it out?
I have found out a way to do it if you are still stuck

 

[neo355]

Hello Jh787, I too have the same problem with an unbranded Wince Device and active sync is disabled, would you please explain how to get past this problem,

Thanks.

 

[jh787]

I dont think the method i used will work as i used active sync.
There is no harm in trying though.
Download the trial version of this program

http://www.youpark.com/trial-download/pocket-controller-pro/3357/

and load it ontp pc and use your pc keyboard to type the code in.

Good luck and let me know how it goes

 

[neo355]

Hello

I have tried the program but as you say it requires the device to be connected with activesync