Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Passthrough?

Status
Not open for further replies.
gbiello

gbiello

Technical User
Aug 9, 2001
442
US
Does anyone know if you can configure a PIX as an in-line device in a pass-through mode. i.e. 192.168.1.2 /C on the inside interface and 192.168.1.3 /C on the outside, so they're both on the same subnet? The gateway would be 192.168.1.1 on the router connected to the outside interface. I've seen this configuration with firewalls from other manufacturers.

This is not my preferred setup, but looking at the network I'm dealing with, it may make my life a lot easier.

TIA
-gbiello
 
Sort by date Sort by votes
No, not until pix 7.0 which has bridging mode as a new feature


Network Systems Engineer
CCNA/CQS/CCSP/Infosec
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

arell12
  • Locked
  • Question
IPSec passthrough
Replies
0
Views
80
arell12
arell12
ACorpolongo
  • Locked
  • Question
Simple PPTP VPN passthrough to SBS Server 1
Replies
2
Views
74
ACorpolongo
ACorpolongo
lowtekkie
  • Locked
  • Question
837 router firewall config to allow NAT passthrough port 80 1
Replies
2
Views
68
lowtekkie
lowtekkie
jgassner2
  • Locked
  • Question
Static mappings and conduits needed for VPN passthrough
Replies
3
Views
99
horus42
horus42
danfranklin
  • Locked
  • Question
SSL passthrough ISA
Replies
0
Views
54
danfranklin
danfranklin

Part and Inventory Search

Sponsor

Back
Top