passing parameter to a subreport

[paverley]

Hello

I have a report with 5 subreports. Each time i run the report i have to pass the same parameter 5 times to my subreports. Is there a way to avoid this?

P.

 

[Katy44]

Go to each subreport in the Design view right click and choose "Change subreport links" (if the CR version is right).
The top one is the parameter from the main report. The bottom one is the parameter in the subreport (you'll need to set these up first in the subreports).
Don't choose the ones beginning 'Pm-'!

 

[paverley]

Great, that's it!! I knew it was possible but i didn't find it
Is it possible to check out my little FAQ i wrote here?

Thanks again!!!!!!!!!!!

 

[Katy44]

You mean the one about calculating problem time?
Sorry - I'm not sure exactly what you mean?

 

[paverley]

Yeah,
nothing special but i saw i didn't get any reaction from anyone, perhaps it wasn't good?

 

[Katy44]

I think it would be impossible to tell how good it is just by reading it. Surely the people who will rate it will be the ones who are reading it and then will use it. So it might take some time for feedback,