PerLovdinger
Programmer
Hi,
I currently have windows98 installed,with large disk support enabled.
In fdisk I have 3 fat32 partitions.
The operating system for windows98 is installed on the C: drive
My place is to install windows nt workstation on the D: drive and
have a dual boot solution.
The problem:
When trying to install NT and assign a partition for NT I get
"8057 Mb Disk 0 at id 0 on bus 0 on atapi does not contain a partition suitable
for starting windows NT.
The hardware must contain NT-compatible partition.
Any ideas ?
thanks beforehand
Per
I currently have windows98 installed,with large disk support enabled.
In fdisk I have 3 fat32 partitions.
The operating system for windows98 is installed on the C: drive
My place is to install windows nt workstation on the D: drive and
have a dual boot solution.
The problem:
When trying to install NT and assign a partition for NT I get
"8057 Mb Disk 0 at id 0 on bus 0 on atapi does not contain a partition suitable
for starting windows NT.
The hardware must contain NT-compatible partition.
Any ideas ?
thanks beforehand
Per