Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Paging to a Biamp Tesira

Status
Not open for further replies.

tnjwinters

Programmer
Joined
Jun 15, 2005
Messages
390
Location
US
Trying to set up overhead paging from a CS1000e 7.5 through an analog line into a Biamp Tesira with a STC-2 analog port. So far it works fine but the Biamp doesn't sense when you hang up. Are there any setting's on the PBX or analog post that might help with this issue.
 
You might try setting LDTA in CLS .
 
Feature description
500/2500 Line Disconnect
500/2500 Line Disconnect is invoked when the system detects
on-hook/disconnect supervision from a party connected to an analog
(500/2500-type) port. Dial tone is sent to this port for a specified period
of time (the default is six seconds) which is defined in LD 15 at the Line
Disconnect Tone Timer (LDTT) prompt.
It is used when the analog (500/2500-type) port is connected to an
automated attendant or voice mail. It allows the system to know that it is
not connected to a telephone, and to disconnect if the other telephone
has hung up (for example, during an automated message or a voice mail
message).
 
LDTA is what I ended up using and it works great. Thank you for the help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top