Ok, here's my question I have a Definity switch that has loud speaker paging configured and it works. But when I look at "Display paging loudspeaker" it looks as if it's never been configured. When you use 129 you get the PA system but I can't figure out how it's programmed. Is there any other way to setup paging without using "Change paging loud".
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Paging "How I don't know"
- Thread starter TechVol
- Start date
AvayaTier3
Technical User
Sounds like you have g3si with a bug in the software. This was a bug in the early R011 loads.
Program paging loud and display it would show blanks.
You need an upgrade or a patch.
If you display port on your tn763 ports, you will most likely see paging.
loads were:
R011i.01.0.060.4
R011i.01.1.060.5
patch fix is 4303
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
36 years Bell, AT&T, Lucent, Avaya
Tier 3 for 26 years and counting
Program paging loud and display it would show blanks.
You need an upgrade or a patch.
If you display port on your tn763 ports, you will most likely see paging.
loads were:
R011i.01.0.060.4
R011i.01.1.060.5
patch fix is 4303
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
36 years Bell, AT&T, Lucent, Avaya
Tier 3 for 26 years and counting
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
