loud speaker paging

[letman2]

we are doing away with our g650s and we need to move our loudspeaker paging to a g450 using a MM711. I tried to change the port on the loudspeaker screen but it would not let me. We are using TAC 3 digit dialing for our paging. any ideas. Right the paging is on TN763 aux trunk board

 

[AvayaTier3]

Command: change paging loudspeaker
delete the entry for the tn763 port

Command: add station xxx (3 digit DAC used for paging loudspeaker)
add this station to mm711 on your g450

 

[dialtonebone]

I would ditch the page port (you have to) and move to a page controller.
Check out the Bogen and Valcom devices that let you connect as a CO port if you want to retain the ability to use the TAC/DAC. You can also modify your dialplan OR modify the number uses dial to page and get a page adapter that uses FXS.

I'd start with any of the page adapters or PCM2000 from Bogen and see if it matches what you are trying to do.

 

[letman2]

First I will remove that old TAC from paging loudspeaker So I change my dial plan and make my 3 digit TAC a 3 digit extension. Then I build an extension using that old TAC and use a port on my MM711 and it should work for paging access.

 

[JefferP]

We use the Bogen UTI1 Paging Adapter (no affiliation with Bogen it just works well for us, and we have several). It has a switch which allows you to use either a trunk or a station along with other nice features. If you want to use a trunk, set up a WATS trunk in CM as Trunk-type: loop and Direction: outgoing then assign the TAC code you want to use. Set the UTI1 to trunk mode.

 

[letman2]

First I will remove that old TAC from paging loudspeaker So I change my dial plan and make my 3 digit TAC a 3 digit extension. Then I build an extension using that old TAC and use a port on my MM711 and it should work for paging access.

Will this work. First I will remove that old TAC from paging loudspeaker So I change my dial plan and make my 3 digit TAC a 3 digit extension. Then I build an extension using that old TAC and use a port on my MM711 and it should work for paging access.