Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
page setup
- Thread starter zuglchaim
- Start date
No, when you're designing a report you define the width and height by dragging the right edge of the report left or right and dragging the bottom edge of the report up or down and sizing the detail and headers etc. You'll get used to it after a while, if ie your report's to wide for the current printer Access will let you know.
Hope this helps.
Hope this helps.
- Thread starter
- #3
tonyflavell
Programmer
If you open a report in design view, click on the detail section of the report to activate it. Select Page Setup from the File Menu, you can specify different formats for different printers. The available settings depend upon your printer driver. Save the report and all the defined settings for each printer will be saved with the report!
Is this what you wanted?
Is this what you wanted?
- Status
Similar threads
- Locked
- Question
- Locked
- Question