Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Option 61
- Thread starter DAT12
- Start date
bigindian65
Technical User
chg it in ld 73, you familiar with that at all? You know how it is now? Have QPC cards in NET with line cable to PRI cards?
Mato' Was'aka
Mato' Was'aka
when you soft change ld 73, you have to move the clock cables on the switch.. you can switch to your backuo clock in 60 to see IF that clears the problem... is your clock taking hits (ld 60 swck 0) or your pri's?
1st symptom of a bad clock source is usually zero t1's up. just a side note, if your not sure about a clocking issue, you will take your switch down.. and it's hard to get it stable with a million codes streaming across the screen.
5 ini's will give you a cold restart to erase the software mistake that killed it... best bet, if a software change cause a broadcast flood, kill power.. (lock the door) bring it back up
john poole
bellsouth business
columbia,sc
1st symptom of a bad clock source is usually zero t1's up. just a side note, if your not sure about a clocking issue, you will take your switch down.. and it's hard to get it stable with a million codes streaming across the screen.
5 ini's will give you a cold restart to erase the software mistake that killed it... best bet, if a software change cause a broadcast flood, kill power.. (lock the door) bring it back up
john poole
bellsouth business
columbia,sc
- Status
Similar threads
- Locked
- Question
