Opt-11 Analog Trunk Card Pin Config at block

[DaveThePhoneDoctorLV]

I have an 8 port Universal Analog Trunk card but I am not sure of the PIN config at the 66 block. Is it 2 ACTIVE then 4 INACTIVE and so on?

 

[MikeRizz]

Skip every other pair. First TN on first pair, skip pair, second TN, skip pair, etc.

 

[DaveThePhoneDoctorLV]

Ok. Then it will be Meridian TN ports: "0,2,4,6,8,10,12,14

 

[MikeRizz]

No, TN's will be 0 thru 7 when programming.

 

[PERRYPJ]

0,2,4,6,8,10,12,14" are your pairs on the MDF block

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[DaveThePhoneDoctorLV]

They are terminating on a 25 pair 66 block trunk card 02 so I have 25 pairs that I am looking at.

So do I start with PIN ( 1 ) and skip every oter PIN on the block?

 

[DaveThePhoneDoctorLV]

Follow up. When I look at the configs via PRT and then enter a TN will I only view or change for example in my case on cards 02 and 13:

02-00 (COT-01)
02-01 (COT-02)
02-03 (COT-03)
etc

13-00
13-01
13-02

?

 

[MikeRizz]

The first TN will be on the first pair, then skip a pair. Second TN on the third pair, skip a pair, etc.. So first TN is on the white/blue, blue white. Second TN will be on the White/green, green white and so on.

 

[bhassell2000]

The first COT circuit will be on the white blue/blue white pair or the first two pins, the skip the white orange/orange white pair and the second COT will be on the white green/green white pair, skip white brown brown white and connect the third circuit on white slate/slate white, trhe connect red orange/ orange red and red brown/brown red, black blue/blue black, and so on

Thanks,

Buddy

 

[DaveThePhoneDoctorLV]

Thank you. When I program a TN for that pair do I still use for example on card 02:

02-00 for COT-01
02-02 for COT-02
02-04 for COT-03

etc

 

[MikeRizz]

No, as I mentioned above you will use 2-0, 2-1, 2-2, etc... up to 2-7.

 

[djstandridge]

Each tn actually has 2 pair, first pair is for dialtone and second is for dry contact that can be used for door openers, alarms, etc...