i read the following in a bulletin from 2008. i have 2 questions about it.
Requirements for implementing one-X Mobile
1) one-X mobile is supported on IP500 running release 4.2 or above.
2) A Mobility license required for each configured user. It is the same license as the Mobile Twinning license in 4.1 and earlier.
3) Trunks that support clearing supervision required. Supported trunk types are:
a) IP500 Universal PRI (Not supported on legacy PRI on a carrier card)
b) IP500 BRI
c) SIP (RFC2833)
question 1: requirement 3a says i can't use a PRI on a legacy card carrier. is this still the case in 6.1?
question 2: if legacy carrier PRI won't work, why?
TIA
Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige
Requirements for implementing one-X Mobile
1) one-X mobile is supported on IP500 running release 4.2 or above.
2) A Mobility license required for each configured user. It is the same license as the Mobile Twinning license in 4.1 and earlier.
3) Trunks that support clearing supervision required. Supported trunk types are:
a) IP500 Universal PRI (Not supported on legacy PRI on a carrier card)
b) IP500 BRI
c) SIP (RFC2833)
question 1: requirement 3a says i can't use a PRI on a legacy card carrier. is this still the case in 6.1?
question 2: if legacy carrier PRI won't work, why?
TIA
Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige