Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Offset-list
- Thread starter lobo66
- Start date
Offset-list artificially inflates the hop count (cost) on RIP routes received or sent on specified interfaces. This command is direction specific. i.e. in (received) or out (sent). If you want to manipulate cost in both directions you must issue two offset-list commands. You can further specify which route(s) gets hop count increased by using an access-list that contains only those networks in the routing table you want to inflate the RIP cost on. If you use a 0 in the access-list position the cost will be applied to all routes depending on choice of "in" or "out".
- Status
Similar threads
- Locked
- Question