Nortel MICS Replacing ISDN cards with LSDS trunk cards

[NiceRing]

I am working on a MICS 2.0 w/NAM 4.0 The MICS 2 ISDN cards plugged in. No longer any need for these and one is defective, 2 dead lines. I am switching to analog rollover lines and will be installing 2 LSDS cards instead. Should I anticipate problems with this switchover? Will I need to reinitialize? Thanks for any help with this. In 25 years of being a Phone Gal, I have never dealt with this issue.

808PhoneGal

 

[curlycord]

Go into hardware programming and change the cards to Loop.



=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[exsmogger]

Ditto what curlycord wrote, but you need to disable the cards in Maintenance first, go to Hardware and change the type, then go back to Maintenance and enable the cards. Give the system about 5 minutes to reconfigure.

Brian Cox
Oregon Phone

http://www.OregonPhone.com

http://www.linkedin.com/in/briancox1952

 

[NiceRing]

Thanks, I knew there was probably a little more to it. J&J Jim says hi.

808PhoneGal