Nortel CS1K MGC

[phonedudeSr]

I need to get all the IP addresses associated with my CS1K systems. CS,SS, MGC, NRS. Where could I find this information.

 

[yyrkroon]

ld 117 stat serv will give you most of the elan info. prt ho in ld 117 will give you the CS elan. Access UCM and you can get all the IP info.

 

[bignose21]

If you have PDT access then go to /u/db/node if you "ls" you should see a nodeXXXX.cfg file if you "cat" that file that contains all the Node information, same can be found in Element Manager in the Node Properties.

For the MGC you can find it in PDT under /u/ipmg/mgc then the individule Loop Shelf folders cat the .xml file, same can be found in Element Manager under the MGC properties, or by login into an MGC at CLI and entering mgcinfoshow.

You can also find the IP information for the Sig Servers if you dont just get it from element manager by login in at CLI and typing ifShow. The eth0 (ELAN), eth1 (TLAN) and if it is a node leader eth1:node (TLAN Node address).

only other thing you might want is LD 48 and "stat elan" to get the Server ELAN addresses (Callpilot, Contact Centre, SIP CTI, etc.)

And as above LD 117
stat serv or stat ss - Sig Server Hostname/ELAN info
Stat host - Call Server address
Stat Route - ELAN GAteway
prt mask - ELAN Subnet MASK
prt ipr - MGC ELAN IP
stat ipm - How long MGC have been registered
stat ucm info - IP address of the UCM/System Manager you are using as a security server
stat ucm sys refresh - registration status of your MGC's

 

[phonedudeSr]

thanks, for the information. What is the method to get the MAC's for the TLAN's

 

[KCFLHRC]

I think you will have to physically look at the cards to get the MAC addresses. Especially the MGC cards and daughter boards.

 

[DisasterMaster]

Look in element manager>System>IP Network>Nodes, Servers, Media Cards.
You should see a list of components. Click on one of them to see MAC Address, Card TN etc…

 

[bignose21]

for MGC login at CLI and i think it is macShow but use help command (help, help system, etc.) and you will find a command that is very similar

 

[bignose21]

If you want Callserver LD 137 STAT ELNK shows it I think and Sig Servers CLI the ifShow gives it I think