I'm working on PM6.5 on Mac Power PC 7500. When either printing OR exporting to PDF tiff graphics wont display at all. Other eps graphics on same pages are ok. I've tried shortening file name, path, fiddling with resolution & compression but nothing seems to work. There are no error messages and all links seem fine. This was ok last week when I worked on the file but now with updates it "magically" stops working! Other files including tiffs are ok but this one document wont work. Any suggestions would be more than welcome.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
non printing tiffs
- Thread starter dtper
- Start date
Hello
Here are some things to try:
Make sure all graphics and the doc are on the harddrive and not on a zip, network, or etc.
Relink all the graphics that are not printing just in case there is corruption on the links.
Remove the graphics completely. Then place them back.
If these suggestions do not work then copy and paste the whole page which contains one of the graphics into a new page.
It sounds as if corruption has attached to the graphics somewhere and one of these should remove the corruption if that is the cause.
Good luck
Here are some things to try:
Make sure all graphics and the doc are on the harddrive and not on a zip, network, or etc.
Relink all the graphics that are not printing just in case there is corruption on the links.
Remove the graphics completely. Then place them back.
If these suggestions do not work then copy and paste the whole page which contains one of the graphics into a new page.
It sounds as if corruption has attached to the graphics somewhere and one of these should remove the corruption if that is the cause.
Good luck
- Thread starter
- #3
Hi Iconpro
Thanks for your speedy response. I think you are right that it was the file that was corrupt and recreated a new doc and pasted all the txt and graphics frames into the new pages and it works just fine. This job has been a nightmare - 1 step forward and 2 steps back!!
Thanks again
DTPer
Thanks for your speedy response. I think you are right that it was the file that was corrupt and recreated a new doc and pasted all the txt and graphics frames into the new pages and it works just fine. This job has been a nightmare - 1 step forward and 2 steps back!!
Thanks again
DTPer
- Status
Similar threads
