we followed the application notes to connect s8700 cm2.0 with a cisco call manager. we can signal but we can not talk. when I do a trace I see the call hitting the trunk but I get a denial event 2300: ept capabilities mismatch. Any suggestions would be welcome.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
no voice between call manager and s8700
- Thread starter letman
- Start date
You did a stat trunk on both the 8700 and Call Manager to make sure that the PTP T1 is up (assuming thats the carrier medium)?
I'm going to run the same setup within the next 2 months for testing.
Alex.
Alex Morales
IT Analyst
Avon Products
2 - Definity G3r CM 1.3.2
2 - Definity G3Si CM 2.1
I'm going to run the same setup within the next 2 months for testing.
Alex.
Alex Morales
IT Analyst
Avon Products
2 - Definity G3r CM 1.3.2
2 - Definity G3Si CM 2.1
how are you connecting these together? i assume some a G6xx gateway with 464 board, to a MGCP cisco gateway? if some im guessing you need to be looking on the cisco side for the problem. Cisco has a doc on there website that shows 2651 (mgcp) to definity V7, thats what we used to connect our v9 to the cisco. the cisco guys had to monkey with thier side.
RTMKCEE
RTMKCEE
- Thread starter
- #4
- Status
Similar threads
- Question