No Signal displayed to monitor

[imryn]

Hi Folks,

I am working with a SH-5921 Panel PC, and I keep getting a " No Signal " displayed to the monitor, and idea what to do, I pulled the Memory, CMOS battery, the hard drive and made sure they were connected properly... now what should I do?

Thanks
Ryan

 

[kjv1611]

Well, first things first.

Is the monitor connected to the computer in the correct location?

Have you tried the same monitor on any other machine? - in case it's the monitor or a bad monitor cable.

Is the computer booting at all?

Stephen
"Jesus saith unto him, I am the way, the truth, and the life:
no man cometh unto the Father, but by me." John 14:6 KJV

 

[imryn]

Stephen,

Thanks for the suggestions. It turns out through process of elimination the power supply was set to 230 and not to 115. therefore not having enough power to boot up from the 120 outlet...

Ryan

 

[kjv1611]

Yep, always checking the simple, not so obvious problems tend to get a lot of things fixed.

Stephen
"Jesus saith unto him, I am the way, the truth, and the life:
no man cometh unto the Father, but by me." John 14:6 KJV