Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

No rommon> at boot

Status
Not open for further replies.
salmans

salmans

IS-IT--Management
Aug 29, 2003
69
US
I have a router with no IOS and I need to load one from a TFTP server. I have the procedures to load an IOS from rommon>, but when I ctrl+break the boot sequence I get a standard ">" prompt and not rommon>. I am unable to use the "set" command to set IP_ADDRESS=, etc... Any suggestions?....thanks in advance!

Do it right the first time, and there won't be a second time!
 
Sort by date Sort by votes
Yes it's a 2514.

Do it right the first time, and there won't be a second time!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

woza
  • Locked
  • Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
525
DrB0b
DrB0b
quazimotto
  • Locked
  • Question
Cisco ASA_5505 VPN to Juniper_SRX210 VPN IS UP_ No Traffic!!!!!!
Replies
0
Views
250
quazimotto
quazimotto
stanlyn
  • Locked
  • Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
496
iggsterman
iggsterman
telemarksman
  • Locked
  • Question
ATA Cisco SPA122 not triggering single line courtesy phone ringer
Replies
0
Views
248
telemarksman
telemarksman
CAROST
  • Locked
  • Question
Cisco 2911 and AT&T 3xT1 issues
Replies
5
Views
292
burtsbees
burtsbees

Part and Inventory Search

Sponsor

Back
Top